Continuous pyrolysis plants are one of the best ways to process waste such as sludge, medical waste, rubber, plastic and scrap tires. These plants have many different benefits.
Firstly, the processing capacity of continuous pyrolysis plants is certainly up to 20-24 tons/day, making these plants an ideal solution for larger plants and even businesses looking to discard large amounts of waste.
The factory is equipped with an automatic feeder. This provides a way to automatically feed waste tires into the reactor, significantly reducing costs and manpower. The continuous tire pyrolysis equipment is also equipped with a shredder. The machine crushes waste tires into small pieces of around 20 mm, helping to optimize pyrolysis efficiency.
These plants can also operate continuously 24 hours a day without any downtime. This machine has the ability to discharge slag and feed materials to the reactor at the same time. Continuous equipment helps save fuel and time compared to traditional pyrolysis equipment.
The most important benefit of continuous pyrolysis equipment is that the reactor is not rotating but stable. This contributes to faster and more uniform heating in the reactor.
Work flow of continuous pyrolysis unit
1. Preprocessing
Before the pyrolysis process begins, waste tires must go through a pre-treatment stage. The equipment consists of a crusher that breaks waste tires into small pieces of around 20 mm.
2. Raw material feeding
After the pretreatment stage, the waste is automatically fed into the reactor. The entrance door will be tightly sealed to avoid any gas leakage.
3. Pyrolysis
The reactor is first heated using a fuel source such as wood, coal, gas or charcoal. The reaction kettle gradually heats up, and when the temperature rises to 250°C, oil and gas are produced during the combustion process.
4. Condensation
The oil and gas generated inside the reactor will be sent to the condensation system, where the gas is converted into liquid oil.
5. Waste gas recovery
Gases that cannot be liquefied under standard pressure will be fed into the combustion system through a safety device. These recovered gases will be used to fuel the reactor, saving energy throughout the operation.
6. Discharge
The steel wire and carbon black are automatically discharged and any waste is sent back to the pyrolysis reactor.

The final product of the continuous tire pyrolysis unit
•Tire oil
The oil can be widely used as industrial fuel material. The oil can even be further refined into gasoline or diesel for use in low-speed engines such as loaders, road rollers and excavators.
•Carbon black
Carbon black is often used in the construction of clay bricks. Additionally, it is made into briquettes or pellets for burning.
•Steel wire
Recycled steel wire from tire pyrolysis plants is recycled again and used to produce steel rods.

